Zhongtian Group

Chinese Manufacturer

Oil Transformer Use Electrical Insulation Material High Density Compressed Wood

Introduction: Electrical laminated wood sheet is widely used into manufacturing some devices for oil-filled transformer, such as upper and lower pressure plate, lead bracket and iron yoke cushion block. And it is used to make clamping device in mutual inductor. It can replace steel plate, insulation paper board, epoxy paper board and epoxy fiberglass board, which can lower the weight of the transformer and the cost of materials. Advantages: 1. Proper specific weight 2. High mechanical strength, 3. Good compatibility with transformer oil 4. Easy machining
Item Unit Index


Density t/m3 0.9~1.1
Rate of water content % ≤ 7
Thickness shrinkage ratio after drying ≤ 1.5
Oil absorption rate > 10
 Ultimate thickness expansion rate after oil impregnation ≤ 0.5
 Compatibility with transformer oil



 Tensile strength (Parallel direction) Mpa ≥ 50
 Compressive strength (Parallel direction) ≥ 50
(Vertical direction) ≥ 120
 Bending strength (Parallel direction) ≥ 100
(Vertical direction) ≥ 100
 Modulus of elasticity (Parallel direction) ≥ 7000


 Volume resistivity MΩ/m ≥ 10a
 Electrical strength (50Hz) 20℃ Transformer (Vertical) MV/ m ≥ 9
90℃ Transformer (Vertical) ≥ 7
20℃ Transformer (Parallel) KV/m ≥ 45
90℃ Transformer (Parallel)) ≥ 35
Dielectric loss factor (tg δ) (50Hz) 20℃ Transformer Oil   ≤ 0.02
 90℃ Transformer Oil   ≤ 0.13
Relative dielectric constant (∑ n)  20℃ Transformer Oil   ≤ 3
 90℃ Transformer Oil   ≤ 3.6
Note: Due to continuous product improvement, the dimensions provided in this sample are for reference only. If necessary, our company can design and produce according to user requirements. Please contact the company in time.

Next Post

Previous Post

© 2019 Zhongtian Group

Theme by Anders Norén